Download Cubot Note 9 official stock firmware

Reload your phone software and fix software faults on Cubot Note 9 with this official stock firmware. Flashing this firmware will remove unroot, delete virus, un-brick and restore the phone to the default factory state. Any customizations done on the device like flashing Custom ROMs and Recovery (e.g. TWRP) will be removed and replaced with stock software.

In that case it is recommended that you backup all important data on your phone before flashing this firmware. Flashing will completely erase the phone data. So, you should only flash your device if you actually know what you’re doing, to avoid causing damage.

Avoid interruption of the flashing and firmware installation process by ensuring the device battery is charged to at least 40%. If there’s a broken link, do not hesitate to report via the comments section.

BuildFirmware
CUBOT_NOTE_9_B041C_V01_20211018Download
CUBOT_NOTE_9_B041C_V02_20211209Download

Flashing instructions

SP Flashtool, Miracle Box, AfterSales SWD Tool, or any other tool that has support for scatter-file can be used to flash this firmware. Once you’ve downloaded the required firmware from the link(s) above, get a non-faulty USB cable, and proceed with the instructions below.

  • Unpack downloaded firmware to an empty folder
  • Make sure you’ve installed the required drivers on your PC.
  • Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
  • Now power off your device and click here to read full flashing instructions if using SP Flashtool.

If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.