Symphony P6 Pro flash file (stock firmware) will help you flash and restore your phone to its default factory state. It will remove root, virus, un-brick, and fix your device if it’s stuck on boot logo. If your phone lags, after flashing it should be better.
It is advised that you backup current firmware and all other important data because, flashing this firmware will completely erase your phone data. Also, only flash your device if you actually know what you’re doing. This is to avoid messing up your device, or turning it into a brick.
Subsequently, ensure the device is charged up to at least 30% so the process is not interrupted due to low battery. If there’s a broken link, do not hesitate to report via the comments section or use the contact form.
Device Model : P6_PRO
Device CPU : MT6735
Device IntName : P6_PRO
Device Version : 5.1
Device Compile : 3/18/2016 2:50:30 PM
Device Project : ALPS.L1.MP3.V2_DWAV6735.65U.O.L1_P2
Device ExtInfo : P6 PRO
You need SP MDT, SP Flashtool, CM2, or Miracle Box, etc. to flash this firmware. Get a working USB cable, then proceed with flashing.
- Unpack downloaded firmware to an empty folder
- Make sure you’ve installed the required drivers on your PC.
- Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
- Now power off your device and click here to read full flashing instructions
If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.