Fero A4001 Plus firmware backup/dump (for CM2)

This Fero A4001 Plus firmware backup for CM2 will help you flash and restore your phone to its default factory state. It will remove root, virus, un-brick, and fix your device if it’s stuck on boot logo. If your phone lags, after flashing it should be better.

Additionally, you should consider making a backup of your current firmware, and all other important data on your phone. Flashing will completely erase your phone. Also, you should only flash your device if you actually know what you’re doing. To avoid messing up your device, or turning it into a brick.

It’s also important that your device is charged up to at least 30% so the process is not interrupted due to shutdown.

If there’s a broken link, do not hesitate to report via the comments section or use the contact form.

File nameSP7731CEB_A4001_Plus_6.0_FSA4001plusv0009_2017-10-19_Fero_A4001_Plus.rar
Size775 MB
FirmwareDownload

Flashing instructions

You need CM2SPD or any other tool that supports pac.sc files before you can flash this firmware.

Get a working USB cable, then follow the instructions below-

  • Unpack downloaded firmware to an empty folder
  • Make sure you’ve installed the required drivers on your PC.
  • Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
  • Proceed with flashing via CM2

If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.