This is stock ZTE e-Learning PAD E8Q (ZTE E8Q) dump (backup/readback) firmware. Like all stock ROMs, it will help you restore your tablet to its default factory state. It also gets rid of root, virus, and offers general fixes for software related problems on your device.
It is recommended that you make a backup of your current firmware, and all other important data on your phone. If you’re not sure of it’s compatibility with your device, flash without preloader.bin file. Also note that flashing will completely erase the device content. So a backup is necessary, just in case.
To avoid interruption of the flashing/ firmware installation process, ensure that your device is charged to at least 40%.
If there’s a broken link, do not hesitate to report via the comments section or use the contact form.
Build | MT6582__ZTE__E8Q__4.4.2__ALPS.KK1.MP1.V2.11 |
Firmware | Download (520 MB) |
ReadInfo | Click to view |
Flashing instructions
You need a tool like SP Flashtool to flash this firmware. Get a working USB cable, then follow the instructions below-
- Unpack downloaded firmware to an empty folder
- Make sure you’ve installed the required drivers on your PC.
- Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
- Now power off your device and click here to read full flashing instructions if using SP Flashtool.
If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.