Cubot X50 factory signed firmware

Cubot X50 official stock firmware will help you flash and restore your phone to its default factory state. It will remove root, virus, un-brick, and fix your device if it’s stuck on boot logo. If your phone lags, after flashing it should be better.

It is advised that you make a backup of your current firmware, and all other important data on your phone. Flashing will completely erase your phone. Also, you should only flash your device if you actually know what you’re doing. To avoid messing up your device, or turning it into a brick.

To avoid interruption of the flashing/ firmware installation process, ensure that your device is charged to at least 30%.

If there’s a broken link, do not hesitate to report via the comments section or use the contact form.

BuildRegionFirmware
CUBOT_X50_B061C_V08_20211124GlobalDownload
CUBOT_X50_B061C-AM_V01_20210918America onlyDownload
CUBOT_X50_B061C_V07_20210716GlobalDownload
CUBOT_X50_B061C_V05_20210605GlobalDownload

Flashing instructions

You need a tool like SP Flashtool, Miracle Box, AfterSales SWD Tool, etc., to flash this firmware. Get a working USB cable, then follow the instructions below-

  • Unpack downloaded firmware to an empty folder
  • Make sure you’ve installed the required drivers on your PC.
  • Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
  • Now power off your device and click here to read full flashing instructions if using SP Flashtool.

If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.