You will be able to restore your Condor Griffe T8 (SP532) smartphone to its default factory state by flashing either of the two firmware on this page. After flashing, root access will be completely removed. It will also remove virus, un-brick, and fix your device if stuck on boot logo. If your phone lags, after flashing it should be better.
Backup your current firmware (if possible), and all other important data on your phone before flashing. Flashing will completely erase your phone. You should only flash your device if you actually know what you’re doing, to avoid messing up your phone, or turning it into a brick.
It’s also important that your device is charged up to at least 30% so the process is not interrupted due to shutdown. Also, do not hesitate to post in comments section of contact us directly, if there’s a broken link on this page.
Build | Firmware | Type |
---|---|---|
Griffe_T8__8.1.0__OPM2.171019.012 | Download | Official ROM | CM2 required to flash |
V94_HW1_V9 | Download | Unofficial |
Flashing instructions
The official firmware linked on this page is a backup (dump) firmware created by CM2 and requires same tool to flash/install the ROM. The unofficial ROM is from a similar device, which has been tested and confirmed to be compatible with Condor Griffe T8 smartphone. It is a PAC file that you can easily flash via SPD Upgrade Tool (R23.19.3301).
So, get a working USB cable, and follow the instructions below to get started-
- Unpack downloaded firmware to an empty folder
- Make sure you’ve installed the required drivers on your PC.
- Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
- Now power off your device and click here to read full flashing instructions if using SPD Upgrade Tool.
If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.