To get a new, fresh and better improved performance on your Alldocube iPlay 40H / iPlay 40 Pro (T1020H/T1020HP), download the firmware linked below and follow the installation instructions. Being a stock (official) firmware, it will restore your device to its default factory state after successful installation. Also, this firmware will remove root, erase virus, and fix your device faulty software/OS. If your phone lags, after flashing it should be better.
Before proceeding with the download and flashing of this official firmware, we recommend that you consider making a backup of your current firmware, and all other important data on the device. This is because, in most cases, flashing will completely erase your phone. In that regards, we further advice that you only flash your device if you actually know what you’re doing.
It’s also important that your device is charged up to at least 40% battery capacity, so that the process is not interrupted due to low battery.
Do not hesitate to report any broken (download) links discovered on this page. Use the comments section at the end of this post, or click the contact us link in the menu.
Alldocube iPlay 40H / iPlay 40 Pro (T1020H) Firmware details & download
|Compatible Models||T1020H / T1020HP|
|Build / Version||iPlay40H(T1020H)-EN-20210911|
You need a tool like SPD Upgrade Tool (or any other tool that supports PAC firmware extension) to flash this firmware. Get a working USB cable, then follow the instructions below-
- Unpack downloaded firmware to an empty folder
- Make sure you’ve installed the required drivers on your PC.
- Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
- Now power off your device and click here to read full flashing instructions if using SPD Upgrade Tool.
If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.